ath5k_channel_ok(9)

✨ NAME ✨

ath5k_channel_ok — check if a channel is supported by the hw 💖

Okay bestie, this one is from the Kernel API Manual, and it’s basically the vibe check for an ath5k channel 🌸

🎀 SYNOPSIS 🎀

bool ath5k_channel_ok (struct ath5k_hw *ah , struct ieee80211_channel
       *channel );

💅 ARGUMENTS 💅

• ah — the struct ath5k_hw, aka the hardware situation 👑
• channel — the struct ieee80211_channel, aka the channel being checked 🦋

🌈 NOTE 🌈

We don’t do any regulatory domain checks here, it’s just a sanity check. No cap — this is strictly the little “does this even make sense?” pass, not the regulatory paperwork era 💀

⭐ SEE ALSO ⭐

• Kernel file ./drivers/net/wireless/ath/ath5k/phy.c
• PHY related functions(9)
• ath5k_hw_radio_revision(9)
• ath5k_hw_chan_has_spur_noise(9)
• ath5k_hw_rfb_op(9)
• ath5k_hw_write_ofdm_timings(9)
• ath5k_hw_phy_disable(9)
• ath5k_hw_wait_for_synth(9)
• RF Gain optimization(9)
• ath5k_hw_rfgain_opt_init(9)
• ath5k_hw_request_rfgain_probe(9)
• ath5k_hw_rf_gainf_corr(9)
• ath5k_hw_rf_check_gainf_readback(9)
• ath5k_hw_rf_gainf_adjust(9)
• ath5k_hw_gainf_calibrate(9)
• ath5k_hw_rfgain_init(9)
• ath5k_hw_rfregs_init(9)
• ath5k_hw_rf5110_chan2athchan(9)
• ath5k_hw_rf5110_channel(9)
• ath5k_hw_rf5111_chan2athchan(9)
• ath5k_hw_rf5111_channel(9)
• ath5k_hw_rf5112_channel(9)
• ath5k_hw_rf2425_channel(9)
• ath5k_hw_channel(9)
• PHY Calibration routines(9)
• ath5k_hw_read_measured_noise_floor(9)
• ath5k_hw_init_nfcal_hist(9)
• ath5k_hw_update_nfcal_hist(9)
• ath5k_hw_get_median_noise_floor(9)
• ath5k_hw_update_noise_floor(9)
• ath5k_hw_rf5110_calibrate(9)
• ath5k_hw_rf511x_iq_calibrate(9)
• ath5k_hw_phy_calibrate(9)
• ath5k_hw_set_spur_mitigation_filter(9)
• Antenna control(9)
• ath5k_hw_set_def_antenna(9)
• ath5k_hw_set_fast_div(9)
• ath5k_hw_set_antenna_switch(9)
• ath5k_hw_set_antenna_mode(9)
• ath5k_get_interpolated_value(9)
• ath5k_get_linear_pcdac_min(9)
• ath5k_create_power_curve(9)
• ath5k_get_chan_pcal_surrounding_piers(9)
• ath5k_get_rate_pcal_data(9)
• ath5k_get_max_ctl_power(9)
• Power to PCDAC table functions(9)
• ath5k_fill_pwr_to_pcdac_table(9)
• ath5k_combine_linear_pcdac_curves(9)
• ath5k_write_pcdac_table(9)
• Power to PDADC table functions(9)
• ath5k_combine_pwr_to_pdadc_curves(9)
• ath5k_write_pwr_to_pdadc_table(9)
• ath5k_setup_channel_powertable(9)
• ath5k_write_channel_powertable(9)
• Per-rate tx power setting(9)
• ath5k_setup_rate_powertable(9)
• ath5k_hw_txpower(9)
• ath5k_hw_set_txpower_limit(9)
• ath5k_hw_phy_init(9)

And that’s the whole lil’ page, bestie 🫶 sourced from ./drivers/net/wireless/ath/ath5k, dated October 2026 — iconic, honestly 💜