LIMIT1(9)

✨ NAME ✨

okay so bestie, this is limit1 — a LinuxCNC HAL component, and her whole entire job is to limit the output signal to fall between min and max 💅 like she is the bouncer at the club and nothing gets past her 🎀

---

🌸 SYNOPSIS 🌸

loadrt limit1 [count=N|names=name1[,name2...]]

that's it. that's the whole vibe check 🦋

---

💖 FUNCTIONS 💖

• limit1.N — requires a floating-point thread ⭐

no cap, if your thread isn't floating-point she will simply not run. she has standards 💀

---

🎀 PINS 🎀

• limit1.N.in float in — the signal coming IN, bestie 👑
• limit1.N.out float out — the signal going OUT, all clamped and well-behaved 💜
• limit1.N.min float in (default: -1e20) — the floor, the absolute lowest she'll let anything go 🍓
• limit1.N.max float in (default: 1e20) — the ceiling, the highest she'll allow, periodt ✨

---

🌈 AUTHOR 🌈

Jeff Epler 🫶 the icon, the legend, the moment

---

💅 LICENSE 💅

GPL — she's free and open source, as she should be 👑

---

so like, that's the whole page, no gatekeeping here 🧚 this was pulled straight from the LinuxCNC Documentation, dated 2026-03-17, in the LIMIT1(9) era — slay, bye bestie 💖✨