geni_se_config_packing(9)

👑 geni_se_config_packing 👑

okay so bestie, welcome to the Kernel API Manual page for geni_se_config_packing — literally the packing configuration of the serial engine. this is giving “small function, very specific job, main character energy.” ✨

🌸 NAME 🌸

geni_se_config_packing — Packing configuration of the serial engine. periodt. 💅

✨ SYNOPSIS ✨

void geni_se_config_packing (struct geni_se *se , int bpw , int
       pack_words , bool msb_to_lsb , bool tx_cfg , bool rx_cfg );

🎀 ARGUMENTS 🎀

• se — Pointer to the concerned serial engine 👀
• bpw — Bits of data per transfer word. 💖
• pack_words — Number of words per fifo element. 🧺
• msb_to_lsb — Transfer from MSB to LSB or vice-versa. 🔁
• tx_cfg — Flag to configure the TX Packing. 📤
• rx_cfg — Flag to configure the RX Packing. 📥

💅 DESCRIPTION 💅

okay so this function is used to configure the packing rules for the current transfer. that’s the whole stated job on this page, bestie — packing rules, current transfer, iconic behavior only. 🦋

🦋 SEE ALSO 🦋

• Kernel file ./drivers/soc/qcom/qcom-geni-se.c
• Overview(9)
• Hardware description(9)
• Software description(9)
• struct geni_wrapper(9)
• struct geni_se_desc(9)
• struct se_fw_hdr(9)
• geni_se_get_qup_hw_version(9)
• geni_se_init(9)
• geni_se_select_mode(9)
• Overview(9)
• geni_se_resources_off(9)
• geni_se_resources_on(9)
• geni_se_clk_tbl_get(9)
• geni_se_clk_freq_match(9)
• geni_se_tx_init_dma(9)
• geni_se_tx_dma_prep(9)
• geni_se_rx_init_dma(9)
• geni_se_rx_dma_prep(9)
• geni_se_tx_dma_unprep(9)
• geni_se_rx_dma_unprep(9)
• geni_icc_set_bw_ab(9)
• geni_se_resources_deactivate(9)
• geni_se_resources_activate(9)
• geni_se_set_perf_level(9)
• geni_se_set_perf_opp(9)
• geni_se_domain_attach(9)
• geni_se_resources_init(9)
• geni_find_protocol_fw(9)
• geni_configure_xfer_mode(9)
• geni_enable_interrupts(9)
• geni_write_fw_revision(9)
• geni_load_se_fw(9)
• geni_load_se_firmware(9)

okay that’s the whole page, bestie 💖 — source/version: ./drivers/soc/qcom; date: October 2026; page: geni_se_config_packing(9). mwah, bye 🫶