NGBE(4)

🌸 NAME 🌸

Okay so bestie, this is the manual page for ngbe — literally the WangXun WX1860 PCI Express 10/100/1Gb Ethernet device 💖. And yes, the manual name is NGBE(4), iykyk.

🎀 SYNOPSIS 🎀

ngbe* at pci?

That's the whole synopsis, periodt ✨.

💅 DESCRIPTION 💅

The ngbe driver provides support for PCI Express Gigabit Ethernet adapters based on the WangXun WX1860AL1 and WX1860A2 Ethernet controllers, including the following:

• LR-LINK LRES2034PT (WX1860AL1) 🌈
• LR-LINK LRES2045PT (WX1860A2) 🌈

The ngbe driver supports IPv4 receive IP/TCP/UDP checksum offload and VLAN tag insertion and stripping. Slay, honestly 💅.

The ngbe driver supports the following media types:

• autoselect — enables auto-negotiation for speed and duplex. 🌀
• 10baseT mediaopt full-duplex — sets 10Mbps operation. 🐢
• 100baseTX mediaopt full-duplex — sets 100Mbps operation. 🏃‍♀️
• 1000baseT — sets 1000Mbps operation. Only full-duplex mode is supported at this speed. ⚡

For more information on configuring this device, see ifconfig(8) 🫶.

🦋 SEE ALSO 🦋

arp(4), ifmedia(4), intro(4), netintro(4), pci(4), hostname.if(5), ifconfig(8) — go read these too, bestie 📚✨.

⭐ HISTORY ⭐

The ngbe driver first appeared in OpenBSD 7.4. Iconic behavior 👑.

👑 AUTHORS 👑

The ngbe driver was written by Kevin Lo <kevlo@openbsd.org> 💜.

---

And that's the whole page, bestie! This one comes from Debian, dated March 31, 2023, under the NGBE(4) manual name. 💅✨🎀