CFUMASS(4)

🎀 NAME 🎀

okay so bestie, this is the CFUMASS(4) page from the Kernel Interfaces Manual, and the main character is cfumass — USB device side support for Mass Storage Class Transport. periodt. 💅

✨ SYNOPSIS ✨

You can compile this driver into the kernel by placing these lines in the kernel configuration file:

             device usb
             device usb_template
             device ctl
             device cfumass

The driver module can also be loaded at boot by adding this line to loader.conf(5):

             cfumass_load="YES"

🌸 DESCRIPTION 🌸

The cfumass driver provides device side support for emulating an USB mass storage device compliant with the USB Mass Storage Class Bulk-Only (BBB) Transport specification, implemented as a ctl(4) frontend driver. not me being obsessed with acronyms, but BBB is iconic here 🫶

To use cfumass, the vibe check is:

• cfumass must be loaded as a module or compiled into the kernel.
• The USB Mass Storage template must be chosen by setting the hw.usb.template sysctl to 0.
• The USB OTG port must be working in USB device-side mode. This happens automatically upon connection to a USB host.
• There must be a ctl(4) LUN configured for the cfumass port.

Upon loading, the driver creates a ctl(4) port named cfumass, presenting the first LUN mapped for that port — usually LUN 0 — to the USB host. See ctl.conf(5) and ctld(8) for details on configuring the LUN. See the cfumass_enable and cfumass_dir rc(8) variables in rc.conf(5) for an automated way to configure it at boot. slay. ✨

🦋 SYSCTL VARIABLES 🦋

These variables are available as both sysctl(8) variables and loader(8) tunables:

• hw.usb.cfumass.debug — Verbosity level for log messages from the cfumass driver. Set to 0 to disable logging or 1 to warn about potential problems. Larger values enable debugging output. Defaults to 1.
• hw.usb.cfumass.ignore_stop — Ignore START STOP UNIT SCSI commands with START and LOEJ bits cleared. Some initiators send that command to stop the target when the user attempts to gracefully eject the drive, but fail to start it when the drive is reconnected. Set to 0 to handle the command in a standards-compliant way, 1 to ignore it and log a warning, or 2 to ignore it silently. Defaults to 1.
• hw.usb.cfumass.max_lun — Max LUN number to report to the initiator (USB host). Must be between 0 and 15. Some initiators incorrectly handle values larger than 0. Defaults to 0.

🌈 SEE ALSO 🌈

• ctl(4)
• umass(4)
• usb(4)
• usb_template(4)
• ctl.conf(5)
• ctld(8)

⭐ HISTORY ⭐

The cfumass driver first appeared in FreeBSD 11.1. iykyk 👑

👑 AUTHORS 👑

The cfumass driver was developed by Edward Tomasz Napierala <trasz@FreeBSD.org> under sponsorship from the FreeBSD Foundation. give him the crown, fr fr. 🫶

---

xoxo, this CFUMASS(4) page is from Debian and dated April 21, 2018 💅🦋