twoftpd-switch(1)

💖 twoftpd-switch — the TwoFTPD back-end switcher 💖

ok so real talk bestie, this one lives in the General Commands Manual, section 1, and it's literally the little bouncer at the door of TwoFTPD who decides which back-end gets to come in. no cap. 🚪✨

---

✨ SYNOPSIS ✨

twoftpd-switch

that's it. that's the whole vibe. no flags, no args, she just knows. 💅

---

🦋 DESCRIPTION 🦋

okay so here's the tea, and it's actually so simple:

twoftpd-switch looks at the value of $SHELL to figure out which back-end it should run. and then it's giving ✨choices✨:

• if $SHELL_WRITEONLY is set and it matches the value of $SHELL → she runs twoftpd-drop
• if $SHELL_READONLY is set and it matches the value of $SHELL → she runs twoftpd-anon
• otherwise? default behaviour, main character energy → she runs twoftpd-xfer

so basically $SHELL is the vibe check, and $SHELL_WRITEONLY / $SHELL_READONLY are the two besties she's comparing it against. if neither of them matches up, twoftpd-xfer is the fallback and honestly she ate. 🍓

---

🌸 NOTES 🌸

before she runs any of these, twoftpd-switch prefixes the commands with the path in which the programs were installed. so she's not just yelling a bare name into the void, she knows exactly where her girls live. 📍🫶

---

👑 SEE ALSO 👑

• twoftpd-xfer(1)

---

and that's the whole page, babe. this icon was written up as twoftpd-switch(1) in the General Commands Manual — go forth and switch those back-ends responsibly. mwah. 💖🎀🌈