tmd710_tncsetup(1)

💖 tmd710_tncsetup 💖

okay bestie, welcome to the General Commands Manual glow-up for tmd710_tncsetup(1) — yes it's a real manual page, yes it's from the General Commands Manual section, and yes we're gonna read the whole thing together. grab a strawberry 🍓

✨ NAME ✨

tmd710_tncsetup — the tool that configures the TNC on several Kenwood radios 🎀

🦋 SYNOPSIS 🦋

tmd710_tncsetup [options]

🌸 DESCRIPTION 🌸

So this manual page documents the tmd710-tncsetup command, briefly. that's literally it, that's the whole vibe. short, sweet, iconic 💅

👑 OPTIONS 👑

these programs follow the usual GNU command line syntax, where long options start with two dashes (-). a summary of options is included below, no cap.

🚨 bestie, real talk: you must supply at least two arguments — the band (0 for Band A, 1 for Band B) and the serial port. no skipping, the tool will not be slaying without them.

• -B, --band — the frequency band to use (0 for Band A or 1 for Band B) 🎚️
• -S, --serialport — the serial port to use for communication with the operation panel 🔌
• -b, --baudrate — sets the HBAUD parameter (that's the TNC speed, 1200 or 9600 baud) ⚡
• -m, --maxframe — sets the MAXFRAME parameter (1-7) 📦
• -p, --paclen — sets the PACLEN parameter (0-255) 📏
• -d, --txdelay — sets the TXDELAY parameter (0-120) ⏱️
• -s, --software-flow — configure the TNC for software flow-control 🌊
• -h, --hardware-flow — configure the TNC for hardware flow-control 🔧
• -c, --callsign — configure the callsign 📻
• -i — Initialize TNC (default is into Packet KISS mode) — 1 : TNC off, 2 : Packet command mode only 🫶
• -V, --version — display the version ✨

💜 AUTHOR 💜

Written by Francois Marier <va7gpl@fmarier.org>

Project Homepage: https://github.com/fmarier/tmd710_tncsetup

and that's the whole page, bestie!! this lil cutie is from the General Commands Manual, dated 3 Jan 2021, and it lives under the name tmd710_tncsetup(1) — go configure some radios, you absolute main character 🦋💖✨ periodt.