SNEK-ITSYBITSY-INSTALL(1)

✨ SNEK-ITSYBITSY-INSTALL ✨

okay bestie, so this is snek-itsybitsy-install from the General Commands Manual (section 1, she's a command, she's a whole vibe) 💅

---

🐍 NAME 🐍

snek-itsybitsy-install — install Snek to an Adafruit ItsyBitsy board 🫶

---

🌸 SYNOPSIS 🌸

snek-itsybitsy-install [OPTION]... [COMMAND]

---

💖 DESCRIPTION 💖

so like, snek-itsybitsy-install installs the Snek programming language onto an Adafruit ItsyBitsy board that's rockin' an ATmega32u4. that's it, that's the job, and she does it flawlessly ✨

---

🎀 OPTIONS 🎀

• -isp <ISP model> — tells her which programmer to use, bestie. the common girlies are 'usbtiny' and 'avrisp2'. the default is 'usbtiny' 💅
• -hex <snek.hex> — picks the hex file that gets loaded onto the board. default is whatever version of Snek you currently have installed, no cap 🌈
• -3v — use the 3v binary instead of the default 5v binary. choose your fighter ⭐

---

🦋 COMMANDS 🦋

• fuseload — sets the target fuse bits for Snek usage and then loads Snek onto the device. this is the default command, she's the main character 👑
• load — loads Snek onto the device without setting the fuse bits first.

⚠️ Snek will not work correctly if the fuse bits aren't set right, so only do this if the target already had its fuse bits set correctly. fr fr, don't play yourself 💀

• fuse — sets the target fuse bits suitable for Snek usage. you must do this before Snek will work on the target device, though you can do it before or after loading the Snek system. you only need to do this once per board, so it's giving "one and done" energy 🎀

---

🌟 AUTHOR 🌟

Keith Packard 💜

---

and that's the whole page bestie, snek-itsybitsy-install serving under the SNEK-ITSYBITSY-INSTALL(1) name in the General Commands Manual — go set those fuse bits and slay 🐍✨💅