shh-service(1)

💅 shh-service — the shh-service(1) glow-up 🎀

okay so you opened the shh-service(1) page from the General Commands Manual and you're like "bestie what is this" — don't worry, I got you. This is the little command that lets you act on a systemd service unit. That's it. That's the whole vibe check. ✨

🌸 SYNOPSIS 🌸

shh service [-h|--help] <subcommands>

literally just type shh service, throw in -h or --help if you're feeling curious, and hand it one of the <subcommands> below. periodt. 💅

🦋 DESCRIPTION 🦋

Act on a systemd service unit. 🫶

That's the official word, and no cap, that's exactly what it does — it's your li'l main character entry point for poking at a service unit through the shh toolbox.

✨ OPTIONS ✨

• -h, --help — Print help. The classic. Ask and it shall tell you things. 💖

👑 SUBCOMMANDS 👑

These are three separate little icons, each with their own manual page. Go read them when you need the full tea. 🍓

• shh-service-start-profile(1) — Add fragment config to service to profile its behavior. iykyk — you're basically adding a lil fragment config so you can watch how the service behaves. 👀
• shh-service-finish-profile(1) — Get profiling result and remove fragment config from service. Grab the profiling result, then clean that fragment config back off the service. No leftovers, no mess. 🧚
• shh-service-reset(1) — Remove profiling and/or hardening config fragments, and restart service to restore its initial state. The big undo button: strips the profiling and/or hardening config fragments and restarts the service so it's back to its initial state. Chef's kiss reset. 🔥

⚠️ ngl, reset actually restarts your service — that's the whole point, it's how the initial state comes back. So don't run it on something precious at a bad moment, bestie. 😭

💜 SEE ALSO 💜

• shh-service-start-profile(1)
• shh-service-finish-profile(1)
• shh-service-reset(1)

and that's a wrap, babe 🌈 — this page lives in the General Commands Manual, it's the service entry under shh-service(1), and yes, it fully ate. 💀🎀