STRUCT SPMI_REGULATOR_INIT_DATA(9)

🎀 struct spmi_regulator_init_data 🎀

Hiii bestie!! This is the struct spmi_regulator_init_data(9) page from the Kernel API Manual, and we are about to make this spmi-regulator initialization data make sense. No cap, it's giving very "tiny struct, important job" energy. ✨

🌸 NAME 🌸

struct spmi_regulator_init_data — spmi-regulator initialization data

✨ SYNOPSIS ✨

struct spmi_regulator_init_data {
    unsigned pin_ctrl_enable;
    unsigned pin_ctrl_hpm;
    enum spmi_vs_soft_start_str             vs_soft_start_strength;
 };

💅 Members 💅

• pin_ctrl_enable — okay so this is a bit mask that says which hardware pins, if any, should be used to enable the regulator. Its value should be an ORing of SPMI_REGULATOR_PIN_CTRL_ENABLE_* constants. If the bit specified by SPMI_REGULATOR_PIN_CTRL_ENABLE_HW_DEFAULT is set, then the pin control enable hardware registers will not be modified. 🫶
• pin_ctrl_hpm — this bit mask says which hardware pins, if any, should be used to force the regulator into high power mode. Its value should be an ORing of SPMI_REGULATOR_PIN_CTRL_HPM_* constants. If the bit specified by SPMI_REGULATOR_PIN_CTRL_HPM_HW_DEFAULT is set, then the pin control mode hardware registers will not be modified. ⚡
• vs_soft_start_strength — this parameter sets the soft start strength for voltage switch type regulators. Its value should be one of SPMI_VS_SOFT_START_STR_*. If its value is SPMI_VS_SOFT_START_STR_HW_DEFAULT, then the soft start strength will be left at its default hardware value. 🌈

🔥 SEE ALSO 🔥

• Kernel file ./drivers/regulator/qcom_spmi-regulator.c
• struct spmi_voltage_range(9)

Source/version: ./drivers/regulator · October 2026 — that was struct spmi...or_init_data(9), signing off bestie 💖✨💅