sht15_send_cmd(9)

💅 NAME 💅

okay so welcome to the Kernel API Manual page for sht15_send_cmd — and yes bestie, it literally Sends a command to the device. 💖

✨ SYNOPSIS ✨

int sht15_send_cmd (struct sht15_data *data , u8 cmd );

🎀 ARGUMENTS 🎀

• data — device state, the whole vibe of the device rn 🫶
• cmd — command byte to be sent, the actual message going out ✨

🦋 DESCRIPTION 🦋

On entry, sck is output low, data is output pull high and the interrupt disabled. That’s the setup, no cap. 🔥

🌈 SEE ALSO 🌈

Kernel file: ./drivers/hwmon/sht15.c

• struct sht15_temppair(9)
• struct sht15_data(9)
• sht15_crc8(9)
• sht15_connection_reset(9)
• sht15_send_bit(9)
• sht15_transmission_start(9)
• sht15_send_byte(9)
• sht15_wait_for_response(9)
• sht15_soft_reset(9)
• sht15_ack(9)
• sht15_end_transmission(9)
• sht15_read_byte(9)
• sht15_send_status(9)
• sht15_update_status(9)
• sht15_measurement(9)
• sht15_update_measurements(9)
• sht15_calc_temp(9)
• sht15_calc_humid(9)
• sht15_status_show(9)
• sht15_status_store(9)
• sht15_temp_show(9)
• sht15_humidity_show(9)
• sht15_invalidate_voltage(9)

and that’s the whole page, bestie — brought to you by ./drivers/hwmon, dated October 2026 💋✨