FUNCTION::SET_USER_INT(3stap)

💖 NAME 💖

function::set_user_int — writes an int value to user memory, and honestly? she's serving exactly one job and she does it slayfully ✨

This one lives in the SystemTap Tapset Reference, section 3stap (yes bestie, that 3stap at the end is the manual section, iykyk) 🎀

---

🌸 SYNOPSIS 🌸

set_user_int(addr:long,val:long)

---

🦋 ARGUMENTS 🦋

• addr — the user address you're writing that int to. Like, the destination. The address of the moment 💅
• val — the actual int that's getting written. The payload. The main character of this whole operation 👑

---

✨ DESCRIPTION ✨

So basically: this function writes the int value to a given user memory address. That's the whole vibe. Write the int, put it at the address, done, iconic.

And like — if writing to the given address fails, it reports an error. It's not gonna sit there and pretend everything's fine. It will tell you. No cap 😭

🚨 OKAY THIS PART IS IMPORTANT: it requires the use of guru mode (-g). Like, you cannot just roll up in normal mode and expect this to work. Guru mode. The -g flag. Required. Periodt 🙈

---

🌈 SEE ALSO 🌈

• tapset::uconversions-guru(3stap)

---

And that's the whole page, bestie! 🫶 This was the SystemTap Tapset Reference, Ver, dated September 2026 — go forth, use your guru mode responsibly, and remember: writing to user memory is a privilege, not a right 💜✨