Config...ed1520(3pm)

✨ NAME ✨

Config::Model::models::LCDd::sed1520 — it's a Configuration class, specifically the LCDd::sed1520 one 💅 and it lives in the Config...ed1520 page of the User Contributed Perl Documentation, bestie 🫶

---

🎀 DESCRIPTION 🎀

So basically these are Configuration classes used by Config::Model — iconic, obsessed, no notes 💖

And the tea is: they're generated from LCDd.conf. That's it, that's the whole vibe ✨

🦋 Elements 🦋

🌸 DelayMult

okay so on fast machines it may be necessary to slow down transfer to the display 🐢 If this value is set to zero, delay is disabled. Any value greater than zero slows down each write by one microsecond. Optional. Type: integer.

upstream_default value:

1

💜 HaveInverter

The original wiring used an inverter to drive the control lines. If you do not use an inverter, set haveInverter to no. Optional. Type: boolean.

upstream_default value:

yes

👑 InterfaceType

Select the interface type (wiring) for the display. Supported values are 68 for 68-style connection (RESET level high) and 80 for 80-style connection (RESET level low). Optional. Type: enum. choice: '68', '80'.

upstream_default value:

80

🧚 InvertedMapping

On some displays column data in memory is mapped to segment lines from right to left. This is called inverted mapping — and no, bestie, do NOT confuse it with 'haveInverter' from above, they are two completely different girlies 🙈 Optional. Type: boolean.

upstream_default value:

no

🍓 Port

Port where the LPT is. Usual values are 0x278, 0x378 and 0x3BC. Optional. Type: uniline.

default value:

0x378

⭐ UseHardReset

At least one display is reported (Everbouquet MG1203D) that requires sending three times 0xFF before a reset during initialization. Optional. Type: boolean.

upstream_default value:

no

---

🌈 SEE ALSO 🌈

• cme

---

and that's the whole page, periodt 💅 this doc was served up by perl v5.40.1 on 2025-03-04 — slay, go forth and configure ur display, ily 🫶✨