ACCEL-CONFIG-CONFIG-USER-DEFAULT(1)

✨ ACCEL-CONFIG-CONFIG-USER-DEFAULT — bestie edition 💖

okay so this is a page from the accfg manual, and it's all about accel-config-config-user-default, the lil command that loads a pre-defined user default configuration. no cap. it's giving "set it and forget it" but make it DSA/IAX.

---

🌸 NAME 🌸

accel-config-config-user-default — load a pre-defined user default configuration 💅

---

✨ SYNOPSIS ✨

accel-config config-user-default [<options>]

So here's the tea: if you run it with no option at all, config-user-default just loads a pre-defined user default configuration. that's it. that's the whole vibe. 🫶

There's a config file template chillin' at contrib/configs/user_default_profile.conf, and if you run

accel-config config-user-default -c user_default_profile.conf

it'll configure all available devices with the template values. and bestie, listen — any modifications you make to that template file should retain the json format. don't be out here breaking json, the json is iconic and we respect it. 🎀

---

🌈 EXAMPLE 🌈

# accel-config config-user-default

The command will load the pre-defined user default config to all available WQs and engines on all available DSA and IAX devices with the following attributes: All WQs and all engines are in group 0 ⭐

WQ attributes:
priority: 1
group_id: 0
block_on_fault: 1
ats_disable: 0
prs_disable: 1
mode: "shared"
type: "user"
name: "user_default_wq"
driver_name: "user"
size: max WQ size / max WQs
threshold: size
max_transfer_size: default value
max_batch_size: default value on DSA. N/A on IAX
op_config: default value

Attributes of all devices and groups are default values. periodt. 👑

---

# accel-config config-user-default -c
/etc/accel-config/contrib/configs/user_default_profile.conf

This one loads the specified user default config file instead. the config file is a template that specifies attributes and devices, and you can edit it per your requirements — it's your world, we're all just living in it 🦋

---

# accel-config config-user-default -d -n <wq_name>

The command will disable all WQs named <wq_name> (default name is "user_default_wq"). lowkey a power move. 💀

---

💖 OPTIONS 💖

• -c, --config-file — to specify the location of the customized user default config file 📁
• -n, --name — to specify WQ name which will be used to disable enabled WQs 🏷️
• -d, --disable — to disable the configured devices and wqs 🙈
• -v, --verbose — verbose ✨

---

not me explaining a manpage like it's a group chat 💀 but fr fr, every flag above is doing exactly what it says, so go off.

---

and that's the whole page, bestie! this was accfg 4.1.8+, dated 07/23/2026 — she's from the ACCEL-CONFIG CONFIG(1) section of the accfg manual and she ATE 💅🌸 mwah, go configure something cute 🎀💜